Grade 1 commercially pure titanium sheet — the softest and most ductile CP titanium grade — for chemical equipment, tanks, ductwork and general industrial fabrication where formability matters more than strength.
Product Overview — Grade 1 is the lowest-alloyed commercially pure titanium grade (UNS R50250). It has the lowest tensile strength of the CP grades but the highest ductility — it bends, forms and cold-works more easily than Grade 2, 3 or 4, and welds cleanly without special pre-heat. These properties make Grade 1 the preferred grade for titanium components that need complex forming, deep drawing or tight-radius bending, where the formability advantage outweighs the lower strength.
Grade 1 sheet is commonly specified for chemical tanks and vessels, fume hoods and ductwork, linings, heat exchanger partitions and low-stress structural panels. It is a stocked grade — thickness, width and length are confirmed per inquiry together with quantity and supply form.
Long-form note for procurement: Grade selection between Grade 1 and Grade 2 often comes down to forming difficulty vs. wall thickness. If the design calls for tight-radius bends, deep dishing or complex cold forming, Grade 1 formability reduces the risk of cracking or springback and can allow thinner sections. For heavier-wall or higher-pressure applications where strength matters more, Grade 2 is usually the default choice. Feinuotai can help with this trade-off when you share the forming requirement and service condition.
Commercially pure titanium, UNS R50250. Lowest strength, highest ductility of the CP grades. Excellent formability and weldability.
Grade 1 is a regular stocked grade for flat titanium products. Available sheet thicknesses, widths and lengths are confirmed at inquiry time.
Grade 1 titanium sheet is supplied against ASTM B265 / B265M — the standard that governs titanium and titanium alloy strip, sheet and plate from 0.2 mm through 200 mm nominal thickness. Additional project-specific codes or specifications may be agreed per order.
Tanks, vessels, linings and reactor components where Grade 1 formability allows complex shapes and tight-radius bends.
Formed and welded Grade 1 sheet fume hoods, exhaust duct systems and laboratory-style ventilation structures.
Thin, flat, corrosion-resistant plates and baffles where Grade 1 formability matters.
Low-stress structural panels, guards and supports where corrosion resistance and formability are required.
Grade 1 is the lowest-alloyed commercially pure titanium grade. It has the lowest tensile strength of the CP grades but the highest ductility — making it the best titanium grade for forming, bending, deep drawing and cold working.
Grade 1 is softer, more ductile and lower strength. Grade 2 has slightly higher tensile strength while still being readily formable. In practice, Grade 1 is chosen when formability and cold-working performance are the primary drivers; Grade 2 is the default choice when a balance of strength, formability and corrosion resistance is needed.
Yes — Grade 1 is a core stocked flat titanium grade. Available thicknesses, widths and lengths are confirmed at inquiry time together with quantity and supply form.
Tell us the required thickness, width, length, quantity and any surface, forming or documentation requirements — we will confirm availability and supply conditions.
Helpful details: Thickness, Width × Length, Quantity, Forming / Surface Requirements
Send Inquiry
Parent product category covering all rolled flat titanium products.
BrowseThe most widely used CP titanium grade — higher strength than Grade 1, still formable.
Browse
Narrow roll form — available in Grade 1 and other grades, supplied as coil or cut-to-length.
Browse